Voice Control Commands

These voice commands can be used anytime, if you have focus in the Archviz window (click inside the window to get focus) and if the VoiceMacro application is running in the background
‘Start Calibration’ or ‘Calibration’
- Start the AutoIPD calibration
‘Entrance’ or ‘Go to Entrance’ or ‘Teleport to Entrance’
- Teleport to the entrance
‘Bathroom’ or ‘Go to Bathroom’ or ‘Teleport to Bathroom’
- Teleport to the bathroom
‘Bedroom’ or ‘Go to Bedroom’ or ‘Teleport to Bedroom’
- Teleport to the bedroom
‘Terrace’ or ‘Balcony’ or ‘Go to Terrace’ or ‘Teleport to Terrace’
- Teleport to the terrace
‘Kitchen’ or ‘Go to Kitchen’ or ‘Teleport to Kitchen’
- Teleport to the kitchen
‘Living Room’ or ‘Go to Living Room’ or ‘Teleport to Living Room’
- Teleport to the living room
‘Change Floor’ or ‘Switch Floor’
- Change the floor texture/material
‘Change Walls’ or ‘Switch Walls’
- Change the walls texture/material

Notes (if the voice commands are not working correctly)
- check that the microphone level is properly set to a value between 75-85 (either through Windows Sound settings or Settings tab in VR Tool application) or fine tune this value according to the surrounding noise level
- check that the English speech recognition Language pack is properly installed and enabled on your computer (in Windows Settings – Region & language)

open the VoiceMacro application window (by clicking on the VoiceMacro icon in notification area) and make sure that the Listen button is active

This page was last modified on March 8th, 2023 at 17:27

< Previous Next >