XTAL body setup

Tracking > Optitrack > XTAL body setup
  • Download the XTAL body file from the Optitrack tracking folder
    • Use the XTAL_xxx.motive body, where xxx corresponds to the serial number of your XTAL headset (serial number can be found on the bottom of the headset or by using the VRTool application)
    • Use the XTAL_xxx.tra body for older versions of Motive software
    • Use the XTAL.motive body if you will not use Active labels in Motive software (but be aware in that case you can only use one XTAL headset in your setup)
  • Click on ‘File’-’Open’
  • Select the downloaded XTAL body
  • Open the ‘Assets’ pane (‘View’-’Assets Pane’)
  • Click on the imported XTAL asset
  • Change the Streaming ID if necessary (this will be shown in the ‘Properties’ tab under General Settings)
  • The XTAL body is now set and ready for use in Motive

This page was last modified on March 7th, 2023 at 15:19

< PreviousNext >