ART
ART page contains specific options for the ART tracking system.
- Enable
- Can be used to select ART as currently active tracking system.
- This option corresponds to the Active Tracking option on the Tracking – Overview page, so any previously selected active tracking system will be replaced by ART if enabled.
- IMU Merge
- When this option is enabled, ART tracking will be merged with the internal IMU sensor data.
- This can lead to faster tracking response during fast rotational movement.
- Axes
- Should be set according to your DTrack room setup (see Room calibration).
- Body ID
- Should be set to the same value as the ID of the XTAL headset body in DTrack Body administration (see XTAL body setup).
- Port
- Can be used to specify a port for communication with the ART controller.
- Should be set to the same port as you’ve selected during DTrack Output setup.
- Local IP
- Can be used to choose a local IP address of your computer, which is on the same network as your ART controller.
- Selecting a local IP address is only necessary if you have multiple active network cards.
This page was last modified on April 4th, 2025 at 16:59
< PreviousNext >