Output setup
- Go to ‘Tracking’-’Output’
- Make sure that at least one of the output channels is active and configured
- Set IP address of the computer where you’ll be using the VR software/applications
- Click on ‘this computer’ if you are using DTrack on the same computer as the VR application
- Select desired UDP port (default recommended value is 5000)
- Set the data divisor to 1
- Make sure that the 6d identifier is active (you can activate all available identifiers)
- Make sure that the ‘act as router for tracking output’ checkbox is unchecked
- Set IP address of the computer where you’ll be using the VR software/applications
- Click on ‘OK’ button
This page was last modified on March 7th, 2023 at 12:44
< PreviousNext >